Triple Axis Accelerometer Breakout – ADXL335

Breakout board for the 3 axis ADXL335 from Analog Devices. This is the latest in a long, proven line of analog sensors – the holy grail of accelerometers.

Information

• The ADXL335 is a triple axis MEMS accelerometer with extremely low noise and power consumption – only 320uA!
• The sensor has a full sensing range of +/-3g.
• There is no on-board regulation, provided power should be between 1.8 and 3.6VDC.
• Board comes fully assembled and tested with external components installed.
• The included 0.1uF capacitors set the bandwidth of each axis to 50Hz.

Quantity : 2

GS407 Breakout Board

This is a breakout board to allow simple access to the tightly pitched pins on the GS406 and GS407 GPS units.

Information

• This board breaks out all of the necessary pins to a row of standard 0.1″ spaced header to allow for easy bread boarding and simple connection.
• Note: TXO and RXI are labeled according to the GS407 datasheet, which is from the point of view of the MCU. Therefore, TXO should connect to TX on your microcontroller, and RXI should connect to RX.
• Note: This is not compatible with the newer GS407 module, as it uses a different connector completely. Please check to make sure this board will work with your module. ktxbai!

Quantity : 2

Breakout Board for Xbee Module

This is a simple breakout board for the popular XBee product from Digi.

Information

• This board breaks out all 20 pins of the XBee to a 0.1″ standard spacing dual row header.
• The spacing between 0.1″ headers is 0.5″ making it breadboard DIP friendly.
• We highly recommend using the female sockets to avoid having to solder the XBee permanently to the breakout board.
• This is the PCB only.

Quantity : 2